When I measure cylinders and tolerance the TP using exact measure it will flip the quadrants from positive to negative on the inspection report up to .010. I ran the same part 3 times and the X,Y coordinates switched from +.005 to -.005 just randomly on different cylinders. I recalculated in legacy and repeated the test and it repeated within tenths. Anyone else run across this?
Welcome to the forum Roadkill2. Can you post a pic of your program so we can help better.
If its changing it could be your alignment so adding a picture will help us.
Welcome to the forum Roadkill2. Can you post a pic of your program so we can help better.
If its changing it could be your alignment so adding a picture will help us.
Hi Mikeg. It is a simple |A|B|C| alignment on a solid block part just for investigational purposes, I can't imagine the alignment being an issue. This happens on a lot of different programs.