I wanted to throw out a quick hello. I've found most of my answers by searching so far, so haven't had much occasion to interact.
I'm new to programming and to CMMs. I've machined a very little bit. I have had a total of about 20 hours of training (8 of it one-on-one, which was fantastic!) with a PC DMIS instructor and am teaching myself as I go along. This is an amazing opportunity from my employer, but also gets a bit lonely, stumbling through things until I understand them enough to move on to my next step.
So, I just wanted to say hi & thank you for all the great info here!
Wait until you tell an engineer his design sucks.... Fun times!
Seriously though, if you haven't had a Geometric Dimensioning and Tolerancing class, start bugging everyone in sight about it. CMM"s and GD&T concepts mesh well together.
Wait until you tell an engineer his design sucks.... Fun times!
Seriously though, if you haven't had a Geometric Dimensioning and Tolerancing class, start bugging everyone in sight about it. CMM"s and GD&T concepts mesh well together.