I’m a postgraduate student running a project on CMM inspection planning.
I’ve structured a short questionnaire for the project and I’d really appreciate it, if you would participate in this.
I'd really appreciate it, if you could forward it to any engineers with CMM experience, you might have in your personnel.
I was going to have a go at it as I'm just sat running parts, but there's no Dat G on the print (I know it shows it on the sketch but I'm not going off that, calling especially when you have Face B is Dat G and such nonsense).
I was going to have a go at it as I'm just sat running parts, but there's no Dat G on the print (I know it shows it on the sketch but I'm not going off that, calling especially when you have Face B is Dat G and such nonsense).
Sounds like an engineer in the making. He'll be spitting out prints, shooting them down to the shop floor and baffling the heII out of machinists and inspectors in no time.