I got in a new disk probe I'm exited to use for a certain series of parts with a stupid tolerance on a little interior groove. I did my math for calibration this morning, then went to build it... Tip not in the list.
After getting angry, searching, reading, searching and reading more, I finally dared to copy another disk from the probe.dat file and alter it, then save it to usrprobe.dat. On the second try, I have it. Now to see if it calibrates and works... but at least I found the probe.dat file and got this far.
Probe colors can be altered for each component, if you want the probe to look fancy or correct. Here's a weblink to all color choices:
https://web.njit.edu/~kevin/rgb.txt.html Also, in that hexagon writeup, the example probe file names have no-no characters in them. Stick to letters_numbers_and_underscores_only in your probe naming conventions, to avert drama.
Probe colors can be altered for each component, if you want the probe to look fancy or correct. Here's a weblink to all color choices:
https://web.njit.edu/~kevin/rgb.txt.html Also, in that hexagon writeup, the example probe file names have no-no characters in them. Stick to letters_numbers_and_underscores_only in your probe naming conventions, to avert drama.