Figured I would ask on here before I call up Hexagon and ask for assistance. So This new company I'm working with has bought a brand new off the shelf 7-10-7 global EPS (aka, Brown&Sharpe) top speed parameters shows 300. This thing is slower at top speed then this old Mistral, I used to run. I would think this thing should go a lot faster. At one facility here, I have a 5-7-5 global EPS top speed 500. I would like to believe that this thing should move, so before I go changing any numbers. I would like to know if this is the best this thing can do or is there a setting that can make this thing move. Calling out
JEFMAN,
AndersI,
Rondog, or anybody else that may know the answer.
i have a global image 7-10-7 and ours is set at 500mm/s under steup options (F5) part/machine tab toward the top is a top speed (mm/sec): option.
although ive never played with it so i dont know if it actually sets the machine speed limit or if its another one of those settings that hexagon put there to make us feel in control but actually doesnt do anything
i have a global image 7-10-7 and ours is set at 500mm/s under steup options (F5) part/machine tab toward the top is a top speed (mm/sec): option.
although ive never played with it so i dont know if it actually sets the machine speed limit or if its another one of those settings that hexagon put there to make us feel in control but actually doesnt do anything
