Figured I would ask on here before I call up Hexagon and ask for assistance. So This new company I'm working with has bought a brand new off the shelf 7-10-7 global EPS (aka, Brown&Sharpe) top speed parameters shows 300. This thing is slower at top speed then this old Mistral, I used to run. I would think this thing should go a lot faster. At one facility here, I have a 5-7-5 global EPS top speed 500. I would like to believe that this thing should move, so before I go changing any numbers. I would like to know if this is the best this thing can do or is there a setting that can make this thing move. Calling out
JEFMAN,
AndersI,
Rondog, or anybody else that may know the answer.
Not EXACTLY sure, since all the options and stuff will be different for different controllers, but under F5, Part/Machine, there is a setting for DISPLAY ABSOLUTE SPEEDS, a box to mark, then a place to put the speed (Sharpe32). I get the same on the Global (whatever it's controller is). How did you get to that page? Is that F5 or something else?
Not EXACTLY sure, since all the options and stuff will be different for different controllers, but under F5, Part/Machine, there is a setting for DISPLAY ABSOLUTE SPEEDS, a box to mark, then a place to put the speed (Sharpe32). I get the same on the Global (whatever it's controller is). How did you get to that page? Is that F5 or something else?
Yeah what
mckenzie said or before you open a program. Under Edit/Machine Interface Setup. And Yeah I know the check box item. Now that Hexagon has made this default, being a % guy I have had to uncheck this box. since what?, 2016 version? because before I could go into Settings editor and change it there. It don't work anymore. But Yeah, I'll try this and crank it up. I have a bad feeling this thing is set to as fast as it will go. Which is really sad.
