Figured I would ask on here before I call up Hexagon and ask for assistance. So This new company I'm working with has bought a brand new off the shelf 7-10-7 global EPS (aka, Brown&Sharpe) top speed parameters shows 300. This thing is slower at top speed then this old Mistral, I used to run. I would think this thing should go a lot faster. At one facility here, I have a 5-7-5 global EPS top speed 500. I would like to believe that this thing should move, so before I go changing any numbers. I would like to know if this is the best this thing can do or is there a setting that can make this thing move. Calling out
JEFMAN,
AndersI,
Rondog, or anybody else that may know the answer.
Not an option on the Sharpe32 under machine interface setup, the Global has it and they are set to 500. I would guess that if those values are set to 250 (even if they could be higher) and you put a move speed of 500 in the program, it will only do the 250.
Not an option on the Sharpe32 under machine interface setup, the Global has it and they are set to 500. I would guess that if those values are set to 250 (even if they could be higher) and you put a move speed of 500 in the program, it will only do the 250.