Fookin last friday, I did an alignment on a fixture and ran a master part multiple of times, but I didnt like one of the move points, so I inserted a new move point. Somehow the CMM went retarded and drove the probe right into the dam table. Bent the **** out of my 3mm probe and busted the module because it was in A0B0. Has anyone else have had this happen to them? Not even a year old global s green and running 2018R2. 2nd time in a month.
I had something similar happen to me before when I was running a program and was viewing another program offline. It flipped a move point and tip change code (supposed to clear part then rotate) in the running program and caused a crash. I'm 99.99% sure the program was fine beforehand, we run production with read only files. After that I've never opened an offline program while somethings running on the machine.
I had something similar happen to me before when I was running a program and was viewing another program offline. It flipped a move point and tip change code (supposed to clear part then rotate) in the running program and caused a crash. I'm 99.99% sure the program was fine beforehand, we run production with read only files. After that I've never opened an offline program while somethings running on the machine.
