Fookin last friday, I did an alignment on a fixture and ran a master part multiple of times, but I didnt like one of the move points, so I inserted a new move point. Somehow the CMM went retarded and drove the probe right into the dam table. Bent the **** out of my 3mm probe and busted the module because it was in A0B0. Has anyone else have had this happen to them? Not even a year old global s green and running 2018R2. 2nd time in a month.
If your on the road long enough you will eventually crash......
Many years ago, I wanted to add a 1/4 inch movment on a move point. Fat fingered it and made an attempt at a 21/2" move at ramming speed. There was stuff in the space I was attempting to move thru. Completely broke off my $15,000 PH9 indexing probe head from the quill
If your on the road long enough you will eventually crash......
Many years ago, I wanted to add a 1/4 inch movment on a move point. Fat fingered it and made an attempt at a 21/2" move at ramming speed. There was stuff in the space I was attempting to move thru. Completely broke off my $15,000 PH9 indexing probe head from the quill
