Hi, if my post is in the wrong section please be so kind & let me know. Same goes to :If this kind of question is already somewhere posted.
Now, i got a technical drawing that gives me a measure "Roundness with a Maximum condition".(its a shaft detail)
My issue with this measure is that it asks a roundness w/o any deviation. Also it gives me a maximum condition so called tolerance(or bonus). Shouldn't there be a +/- tolerance for this. If my question is unclear let me know & i will try to rephrase it.
I have learned a TON from you Andersl, 99.999% of the time I will always defer to you/you guys on the forum and trust what you say..but based off of what I "think" I know, I "think" his DRF is invalud.
I hope a true blue GDT expert can hop on here and throw in their 2cents.
I have learned a TON from you Andersl, 99.999% of the time I will always defer to you/you guys on the forum and trust what you say..but based off of what I "think" I know, I "think" his DRF is invalud.
I hope a true blue GDT expert can hop on here and throw in their 2cents.