With that said, I would like your opinions on the attached crude drawing. It's third angle projection and in accordance with ASME Y14.5M-1994. The material at it's thickest point is 1 1/4". The total length of the part is 60". Here are the questions
1. How would you align this part for the position and profile call-outs back to ABC?
2. Since B is a huge diameter and C is a width, what would you use to rotate to?
3. PC-DMIS can't solve a constructed line from a circle/cylinder (B) to a width/mid-line/mid-plane (C). So what would you use instead to comply with the standard and satisfy the software?
There's some dissension here with regard to designer intent as well as compliance to the standard.
Thank y'all again for taking the time to share!!!
Attached Files