Only sharing part of the print for nondisclosure purposes, but there was a lot wrong with it. Thought I would share this since it has been so annoying for me.
They put a position dimention on many of the faces when they clearly needed/wanted a surface profile.
They also had an M modifier on almost everything including: datums that are planes, flatness, and one distance dimension
Currently talking with my contact to see if we can get this straightened out.
I have a customer who is calling out a hole position |Ø0.005|A|B|C|. Part is a tall cylinder, top face is -A- and the inside diameter is -B-. -C- does not exist on the print and they refuse to change their print.. They straight up do not understand the first thing about GD&T, do not even know what a datum is, and are fighting the point tooth and nail. After a week they suggested that I take a MANUAL point on -A- and call that point -C- and then rotate to that lo. We're so done dealing with these people my boss literally told me "just do what you're told no matter how dumb it is"
I have a customer who is calling out a hole position |Ø0.005|A|B|C|. Part is a tall cylinder, top face is -A- and the inside diameter is -B-. -C- does not exist on the print and they refuse to change their print.. They straight up do not understand the first thing about GD&T, do not even know what a datum is, and are fighting the point tooth and nail. After a week they suggested that I take a MANUAL point on -A- and call that point -C- and then rotate to that lo. We're so done dealing with these people my boss literally told me "just do what you're told no matter how dumb it is"