I am getting a low air pressure warning this morning and it looks like the pressure is slightly low (5-10PSI).
Our compressor seems to be working fine and the dryer seems to be getting proper air flow and is purging air normally.
Also we had a power outage last night. That might be important info.
Solved!
Comment # 3 on this thread
https://www.pcdmisforum.com/forum/pc...e-is-low-error
Locate a knob on the right side towards the back of the X axis rail/beam. Hold the Z with your hand and turn that knob about a 1/4 turn or until you hear a 'click'. That knob adjusts the Z counterweight so try to adjust it back as best as you can after turning it.
This procedure was a common thing after long weekends or when the shop air would 'cut off' unexpectedly.
