Wanting some advice on Alignment. I have a part with 5 straight in line holes, the top is a datum. The composite feature frame call for a TP .8 to AD, I created a line between all 5 holes then rotated to that line and set the axis on the datum
That should work for having the CMM to measure the holes, for evaluating, you would need to allow the four holes to rotate around D (D is a single hole?).
If you are using XactMeasure or GeoTol and have your datum definitions correct, you are good to go. Not sure about legacy though.
That should work for having the CMM to measure the holes, for evaluating, you would need to allow the four holes to rotate around D (D is a single hole?).
If you are using XactMeasure or GeoTol and have your datum definitions correct, you are good to go. Not sure about legacy though.