So I have a simple alignment. Plane A, circle B, circle C. I Leveled to the plane A and origin Z to it. Translate XY to circle B. Rotate to a line made from B to C. Done.
A different programmer believes I
mustrotate before translating.... I totally disagree on this simple alignment. Using Legacy btw.
ONE: You should have one alignment that locks all 3 DOF. It was proven in the past that if you don't have that, Pcdmis could (randomly) change nominals on you.
Myself, I've always done LEVEL, ROTATE, ORIGIN, ROTATE OFFSET (if needed) and ORIGIN OFFSET. In that order.
ONE: You should have one alignment that locks all 3 DOF. It was proven in the past that if you don't have that, Pcdmis could (randomly) change nominals on you.
Myself, I've always done LEVEL, ROTATE, ORIGIN, ROTATE OFFSET (if needed) and ORIGIN OFFSET. In that order.
Interesting on the nominals... Ive never had this happen as long as all 6 DOF were locked... Ill keep and eye on it though. Anyway, will the alignment work as I have. I did it in order of precedence... A's DOF then B's DOF and finally C's DOF