Hey guys. Could one of you explain this for me. I thought probe compensation was correct prior to a part alignment. Because even without a part alignment there is still a coordinate system within the CMM. Why wouldn't it be correct without a part alignment?
With a scanning head, selecting "3D" mode in the measured point (instead of work plane), selecting 'fine manual probing" in F10 should give a compensation not to far from the right one (IMO)
With a scanning head, selecting "3D" mode in the measured point (instead of work plane), selecting 'fine manual probing" in F10 should give a compensation not to far from the right one (IMO)