So to those that draw models. Do you build them to print tolerance exactly or do you build them to nominal?
example a hole that is 1" plus .004 minus 0. Do you build the model so it's 1.002" or per the print 1" plus .004 minus 0? If you build to nominal is that affecting your pcdmis program?
It's becoming very common to get prints that only have hole callouts and critical dims and everything else is basic profile or TP with basics pulled from the model
It's becoming very common to get prints that only have hole callouts and critical dims and everything else is basic profile or TP with basics pulled from the model