Not necessarily CMM related. Lets say I have a part with an OD with a size callout of Ø1.500 +0.001/-0.000 and the surface has a taper of about 0.002 over the length of the part. At the one end it measures 1.4997 and at the other end it measures 1.5012. How do you report the size of the dimension?
In such cases, I report several diameters indicating the level at which it was measured with a comment about it, then the engineers deal with it, whether it suits them or not.
Well in that case discuss this with the big shots. If they are so scrooge-like by not hiring separate engineer on the site then it's their problem. 100 employees???? I once worked at a stamping shop with 30-40 employees & yet we had one QC manager, one QC engineer & one inspector. Not to mention 2 engineers.
Well in that case discuss this with the big shots. If they are so scrooge-like by not hiring separate engineer on the site then it's their problem. 100 employees???? I once worked at a stamping shop with 30-40 employees & yet we had one QC manager, one QC engineer & one inspector. Not to mention 2 engineers.
