Do any of you use a granite plate offline to check parts? If so, do any of you have a thread insert pattern on it? I am about to by one and am trying to decide what would be the most helpful hole patter to have. I was thinking about staggering some 3/8-16 inserts along one short edge about 3 inches in. 3ft*6ft*12inch granite.
You do have to be careful with threaded inserts in granite. It is very possible to overtighten and pull the inserts out. If the plate is outside your door, someone will do just that.
You do have to be careful with threaded inserts in granite. It is very possible to overtighten and pull the inserts out. If the plate is outside your door, someone will do just that.
