Result of surface profile tolerance

Hello !! I am having to use two software in parallel, PC DMIS and Touch DMIS, with Touch Dmis software, I get a negative value for a result of Surface Profile, I have not seen this before, can you Can you instruct me why it is like that?

Attached Files

Parents

vpt.se over 1 year ago

If the drawing/customer calls for the use of the ASME standard, then you already have the answer.

If it calls for ISO, you need to multiply the result with 2 = 0.797 with a tolerance of 1.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

vpt.se over 1 year ago

If the drawing/customer calls for the use of the ASME standard, then you already have the answer.

If it calls for ISO, you need to multiply the result with 2 = 0.797 with a tolerance of 1.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

sonxilanh1 over 1 year ago in reply to vpt.se

thật tuyệt vời , tôi vừa kiểm tra lại, đúng là bản vẽ đang sử dụng tiêu chuẩn ISO1011, nhưng như bình luận của 1 thành viên khác, cần chuyển tiêu chuẩn đánh giá từ ASME => ISO, nhưng trên TOUCH DMIS , tôi không biết cách làm như nào, bạn có biết về TOUCH DMIS hoặc bạn có biết ai đã và đang sử dụng nó không ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
vpt.se over 1 year ago in reply to vpt.se

Sorry, no - never used TouchDMIS. You should contact their support for questions like this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
sonxilanh1 over 1 year ago in reply to vpt.se

Vâng , tôi sẽ thử nó, cảm ơn bạn về những chia sẻ ^^
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel