Problem Alignments

Hi, this my example:

            STARTUP    =ALIGNMENT/START,RECALL:,LIST=YES
            ALIGNMENT/END
            MODE/DCC
            MOVESPEED/ 100
            FORMAT/TEXT,OPTIONS, ,HEADINGS,SYMBOLS, ;NOM,TOL,MEAS,DEV,OUTTOL, , 
            LOADPROBE/1MM
            ASSIGN/AUX=1
            IF_GOTO/AUX==1,GOTO = A1
            IF_GOTO/AUX==2,GOTO = A2
I0         =LABEL/
            MOVE/POINT,NORMAL,<0,0,200>
            PROGRAM/END

A1         =LABEL/
            RECALL/ALIGNMENT,EXTERNAL,a1,ALINHAMENTO_BASE_1:a1
            GOTO/I0
A2         =LABEL/
            RECALL/ALIGNMENT,EXTERNAL,a1,ALINHAMENTO_BASE_2:a1
            GOTO/I0

I want use 2 alignments in the same program... but this dont work... Any Solution?
________
Homemade Vapor

Parents

John Kingston over 14 years ago

With alignments, PC-DMIS recognizes the last alignment that the program has passed.
I have many situations where I can use one of two fixtures. For this, I have created external Alignments and recall them using variables.

TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            FORMAT/TEXT,OPTIONS,HEADINGS,SYMBOLS, ;NOM,TOL,MEAS,OUTTOL, , 
C1         =COMMENT/INPUT,Enter FIX1 for FIXTURE1,
                         ,FIX2 for FIXTURE2.
            ASSIGN/V1 = C1.INPUT
            RECALL/ALIGNMENT,EXTERNAL,V1,FIX2:fix2
            MODE/DCC
            MOVE/POINT,0,0,8
            COMMENT/OPER,Load Probe Star.
                        , 
                        ,Place part seal bore UP.
                        ,Hold on I.D.
                        , 
                        ,Press DONE / ENTER when ready.

Reply

John Kingston over 14 years ago

TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            FORMAT/TEXT,OPTIONS,HEADINGS,SYMBOLS, ;NOM,TOL,MEAS,OUTTOL, , 
C1         =COMMENT/INPUT,Enter FIX1 for FIXTURE1,
                         ,FIX2 for FIXTURE2.
            ASSIGN/V1 = C1.INPUT
            RECALL/ALIGNMENT,EXTERNAL,V1,FIX2:fix2
            MODE/DCC
            MOVE/POINT,0,0,8
            COMMENT/OPER,Load Probe Star.
                        , 
                        ,Place part seal bore UP.
                        ,Hold on I.D.
                        , 
                        ,Press DONE / ENTER when ready.

Children

No Data