Use as you like. You could also change CODE to find MIN point.
$$ NO,. $$ NO,. How To Find the MAX POINT in a feature set of limited size $$ NO,. $$ NO,. Input the number of the feature set point you want to start from $$ NO,. ASSIGN/NHITS = SCN1.NUMHITS L1 =LABEL/ C1 =COMMENT/INPUT,NO,"ENTER START POINT." , ,"THE FEATURE HAS ===> " +NHITS +" POINTS" COMMENT/REPT,"the feature has ===> " +NHITS + " points" $$ NO,. $$ NO,. Test value to be sure it is legal $$ NO,. IF/C1.INPUT < 1 OR C1.INPUT+1 > SCN1.NUMHITS COMMENT/OPER,NO,you have entered an illegal number. TRY AGAIN! GOTO/L1 END_IF/ $$ NO,. $$ NO,. Input the number of the feature set point you want to end at $$ NO,. L2 =LABEL/ $$ NO,. C2 =COMMENT/INPUT,NO,"ENTER END POINT." , ,"MUST BE BETWEEN " +C1.INPUT + " AND " +NHITS $$ NO,. $$ NO,. Test value to be sure it is legal $$ NO,. IF/C2.INPUT <= C1.INPUT COMMENT/OPER,NO,you have entered an illegal number. TRY AGAIN! GOTO/L2 END_IF/ IF/C2.INPUT > SCN1.NUMHITS COMMENT/OPER,NO,you have entered an illegal number. TRY AGAIN! GOTO/L2 END_IF/ $$ NO,. $$ NO,. V1 will be the position of the MAX POINT in the LIMITED feature set $$ NO,. ASSIGN/V1 = MAXINDEX(SCN1.HIT[(C1.INPUT)..(C2.INPUT)].Z) $$ NO,. $$ NO,. V2 will be the position of the MAX POINT in the FULL feature set $$ NO,. ASSIGN/V2 = C1.INPUT+V1 $$ NO,. $$ NO,. V3 is used for the building of the generic point $$ NO,. ASSIGN/V3 = "PNT"+V2 $$ NO,. GEN_FEAT_1 =GENERIC/POINT,DEPENDENT,RECT,$ NOM/XYZ,V3.TX,V3.TY,V3.TZ,$ MEAS/XYZ,V3.X,V3.Y,V3.Z,$ NOM/IJK,V3.TI,V3.TJ,V3.TK,$ MEAS/IJK,V3.I,V3.J,V3.K $$ NO,. $$ NO,. To report the MAX POINT : $$ NO, Dimension any Feature $$ NO,. DIM LOC1= LOCATION OF POINT PNT10 UNITS=MM ,$ GRAPH=OFF TEXT=OFF MULT=10.00 OUTPUT=NONE AX MEAS NOMINAL +TOL -TOL DEV OUTTOL Z 0.0063 0.0000 1.0000 1.0000 0.0063 0.0000 END OF DIMENSION LOC1 $$ NO,. $$ NO,. Then you must change the name of the PNT that was dimensioned $$ NO, In this example you must highlight PNT10 with the cursor and then change it to "PNT"+V2 $$ NO,. DIM LOC2= LOCATION OF POINT "PNT"+V2 UNITS=MM ,$ GRAPH=OFF TEXT=OFF MULT=10.00 OUTPUT=REPORT AX MEAS NOMINAL +TOL -TOL DEV OUTTOL Z 0.0961 0.0000 1.0000 1.0000 0.0961 0.0000 END OF DIMENSION LOC2 $$ NO,.