Surface Normal Deviation of points in FCF

ok, so here's what i'm trying to do...

i have a profile,

i would like the the surface normal deviation of the points in a table like this

t1 t2 t3 t4
t5 t6 t7 t8

instead of the long table of xyz ijk

i need it from the fcf b/c of the best fitting that has been done

i had tried

ASSIGN/V2 = DOT(SCN1.HIT[1].XYZ-SCN1.HIT[1].TXYZ,SCN1.HIT[1].IJK)

but this doesn't match the fcf deviations as they have been best fit

any ideas?

thanks

-cappy

Parents

Josh Carpenter over 11 years ago

I think what vpt (and me) were hoping for was a way to create an alignment that uses the Xact fit shift. There are all sorts of applications for this. Using the available options in best-fit alignment is not the same, because they do not attempt to fit within a tolerance zone.

Ah, that would be a trick indeed. I'm not quite that tricky.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Josh Carpenter over 11 years ago

I think what vpt (and me) were hoping for was a way to create an alignment that uses the Xact fit shift. There are all sorts of applications for this. Using the available options in best-fit alignment is not the same, because they do not attempt to fit within a tolerance zone.

Ah, that would be a trick indeed. I'm not quite that tricky.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data