Your Products have been synced, click here to refresh
So are you talking to change it like this:
For i = 1 To PCDCommands.Count
Set StrDimID = PCDCommands(i)
If StrDimID.IsDimension Then
Set ObjDimCmd = StrDimID.DimensionCommand
Set StrDimFeature = StrDimID.ID
Set StrDimNominal = ObjDimCmd.Nominal
Set StrDimUTol = ObjDimCmd.Plus
Set StrDimLTol = ObjDimCmd.Minus
'Set MyReading1 = StrDimID. Measure ' unsure about this data enumerator, could be 'Actual' instead of 'Measure'
And then, I wasn't meaning the tolerances, but the AX, which I only assume is axis and tells whether you are on the x axis, the y axis, z axis, or measuring a diameter (d). Which I have a variable of StrDimType on top for it, but it isn't called out in the code you laid out for me. And of course that has gotten me all confused again.
Thank you so much for your patience and help.
Kelly
So are you talking to change it like this:
For i = 1 To PCDCommands.Count
Set StrDimID = PCDCommands(i)
If StrDimID.IsDimension Then
Set ObjDimCmd = StrDimID.DimensionCommand
Set StrDimFeature = StrDimID.ID
Set StrDimNominal = ObjDimCmd.Nominal
Set StrDimUTol = ObjDimCmd.Plus
Set StrDimLTol = ObjDimCmd.Minus
'Set MyReading1 = StrDimID. Measure ' unsure about this data enumerator, could be 'Actual' instead of 'Measure'
And then, I wasn't meaning the tolerances, but the AX, which I only assume is axis and tells whether you are on the x axis, the y axis, z axis, or measuring a diameter (d). Which I have a variable of StrDimType on top for it, but it isn't called out in the code you laid out for me. And of course that has gotten me all confused again.
Thank you so much for your patience and help.
Kelly
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |