I have an airfoil cover that I analog scan in about 26 sections. I report profile of each section but was asked to output XYZ of each point. I'm able to do so using loops within PC-DMIS but it takes about 25 minutes just for this output alone. I'm now being asked to report deviation from nominal of each point in each scan. Can someone point me in the right direction?
You are probably being asked for the T-value. I believe JEFMAN has posted a way to calculate the T-value from XYZ/vector values if you can't use the "normal" dimensioning.
You are probably being asked for the T-value. I believe JEFMAN has posted a way to calculate the T-value from XYZ/vector values if you can't use the "normal" dimensioning.