Hi all,
Is it possible to change diameter or offset values of a probe with a code ? (instead of open the probe window / edit / write the values).
Ok, it seems to be dangerous, but it could be useful.....
Thanks again DJAMS !
I "played" with the code, it works fine ! I'm happy to use "reset to theo values" to find some values close to start one !
Now, don't forget it's friday... Happy week-end, all !!!!!
Thanks again DJAMS !
I "played" with the code, it works fine ! I'm happy to use "reset to theo values" to find some values close to start one !
Now, don't forget it's friday... Happy week-end, all !!!!!
!