Has anyone had a program lose the line that says "End of dimension" after True position and location dimensions?
Halfway through the reporting section of a program I have lost these "end of dimension" lines.
The problem is the dimension stays open so if i hit enter at the end of the dimension it just keeps adding more axis. I can not insert dimension's, comments,alignments,variables...
nothing! in this area of the program "No legal insertion point below" is the message i get. This goes on for the last 3000 lines of the program.
Currently I am re-dimensioning this section(Which will take a day or two...aargh!) of the program & curious to know why or how this happened.
Any comments?
I just realized i posted this in the code forum.....Sorry about that..
Sorry to bump an old thread but I have this issue in CAD++ 2011 MR1 and the above link is dead. Does anyone know where I can currently find the file (or if it will even work on 2011)? I tried searching the PCDMIS site but can't find snot.
Sorry to bump an old thread but I have this issue in CAD++ 2011 MR1 and the above link is dead. Does anyone know where I can currently find the file (or if it will even work on 2011)? I tried searching the PCDMIS site but can't find snot.