Graphical Report control

I am dimensioning a scanned line across the face of a part using Profile of a Line. I have a dozen or more to do like this and it slows the report down considerably. Is there a way to turn on the graphical ONLY when at high limit or over tolerance??
Thanks!

AndersI over 5 years ago

Maybe by putting the graphic in a Custom Report, and showing that IF oot? (One CR for each graph)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

bfire85 over 5 years ago

Do a IF/END_IF statement with an analysis command inside of that.

DIM 13A= PROFILE OF SURFACE OF SET DIMPLE_PLN    FORMANDLOCATION  UNITS=MM ,$
GRAPH=OFF  TEXT=OFF  MULT=20.00  ARROWDENSITY=100  OUTPUT=BOTH
AX    NOMINAL        MAX        MIN       +TOL       -TOL        DEV     OUTTOL
M        0.000     -0.014     -0.115      0.100      0.100      0.115      0.015 <--|----
            IF/13A.OUTTOL>0
              ANALYSISVIEW/13A,,
            END_IF/