hello,
if true position reports center of a line? I have to report true position of slot's width, so the way Im choosing is constructing the line between two arcs of the slot and tolerance the lane in relative to just one axis...but if reporting only the center position, so the slot's direction (if deviated) is not controlled ? Thanks a lot.
hello,
if true position reports center of a line? I have to report true position of slot's width, so the way Im choosing is constructing the line between two arcs of the slot and tolerance the lane in relative to just one axis...but if reporting only the center position, so the slot's direction (if deviated) is not controlled ? Thanks a lot.
The best way to measure true position of slots are to construct a slot feature using those two arcs. Then you can simply get the true position (with the relative alignment) as well as report the length and width.
