Feature With HUGE Tolerance

I am being asked to confirm the orientation of a round clip, similar to a hose clamp. The dimension is an angle, and the tolerance is ±45°. Since the clip can be anywhere in this 90° range, what is the best way for the CMM to 'find' it? (without taking manual hits on it of course). The polar radius of the clip location is about 35 mm if that helps.

Parents

Matthew D. Hoedeman over 14 years ago

Sounds like one of my parts that has a 0 to 8 mm internal radius. one supplier makes the part around 3 mm the other is banging the 8 right on the edge.
I had to make two different programs. Now I am waiting for us to get another new supplier to make it as close to zero as he can get it

Have you tried making the program "self adjusting", use a single point in the radius to determine WHICH size radius the program will check? Might be something to look into.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Matthew D. Hoedeman over 14 years ago

Sounds like one of my parts that has a 0 to 8 mm internal radius. one supplier makes the part around 3 mm the other is banging the 8 right on the edge.
I had to make two different programs. Now I am waiting for us to get another new supplier to make it as close to zero as he can get it

Have you tried making the program "self adjusting", use a single point in the radius to determine WHICH size radius the program will check? Might be something to look into.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data