Here's what I'm trying to do - Display a message, prior to printing results, that says "There are N dimensions out-of-tolerance, do you still want to print the report?" Of course, I could accomplish this by doing a whole lot of computations with expressions, but I'd thought I'd first inquire if PC-DMIS can set a flag, based upon the Dimension command, that I can convert into a counter.
So dph51, I tried the assignment I mentionned upon under PC-DMIS 2014, and it works well !!! Here are the commands I use at the end of my program :
But I have another question : Is it possible to visualize the report when we get OOT dims ? Because the report window shows nothing when its finished, we have to click "redraw the report". Is there an automatic command that able to doing this ?
Thanks for this by the way. Before, I had the reports print automatically without giving the operator the choice to save or the destination. I used my same print command in the place of yours and now it asks where to save the report. Any advice on this?
So dph51, I tried the assignment I mentionned upon under PC-DMIS 2014, and it works well !!! Here are the commands I use at the end of my program :
But I have another question : Is it possible to visualize the report when we get OOT dims ? Because the report window shows nothing when its finished, we have to click "redraw the report". Is there an automatic command that able to doing this ?
Thanks for this by the way. Before, I had the reports print automatically without giving the operator the choice to save or the destination. I used my same print command in the place of yours and now it asks where to save the report. Any advice on this?
