"primary point does not lie on secondary axis, tertiary not allowed"

Having a small hurdle to overcome here, would greatly appreciate a little advice if you got the time.
Profile of a Surface execution scenerio...(dmis cad, not ++)

Primary -A- = Zplus plane (leveled and z origin)
Secondary -B- = Line on Yminus face, edge of zplus (rotated xplus about zplus and y origin)
Tertiary -C- = circle in hole on Yminus face (x origin)

(As Drawing indicates)

Aligned with CAD, Online

Series of points (contour in an area within zplus), as a Feature Set. FCF set up and defined datums accordingly.
When clicking create, Message window appears which states... "primary point does not lie on secondary axis, tertiary not allowed".

Obviously, I need to correct something here, but am unsure of what, and again would greatly appreciate any advice given.
Thank You.

Parents

Matthew D. Hoedeman over 9 years ago

Well in that case the correct method would be to do your iterative alignment using the points given, then construct Alignment constructions (Plane / Line, Origin Pnt) then define them as the datum features and use them in the FCF.

Make sure you get the workplanes right when constructing the Alignment constructions.

The other option, unless you are drigging and scratching for bonus tolerance is to simply use "USE CURRENT ALIGNMENT" instead of building datums.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Matthew D. Hoedeman over 9 years ago

Well in that case the correct method would be to do your iterative alignment using the points given, then construct Alignment constructions (Plane / Line, Origin Pnt) then define them as the datum features and use them in the FCF.

Make sure you get the workplanes right when constructing the Alignment constructions.

The other option, unless you are drigging and scratching for bonus tolerance is to simply use "USE CURRENT ALIGNMENT" instead of building datums.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data