I am measuring a cylinder using 3 separate loops using auto point. I know there is a way to construct a cylinder from those but I can't remember exactly how. The software stores each point by PNT1[1] PNT1[2] etc but can't figure out how to extract each of those. Any help on this would be usefull. The reason behind using the loop is due to a hexical feature of three areas so I just offset in Z and angle.
Construct your feature with the points you can see in the selection window, then edit the code to change the text as needed and to add those you couldn't select.
Construct your feature with the points you can see in the selection window, then edit the code to change the text as needed and to add those you couldn't select.