Is there an easy way to report out the transformation matrix that is applied by an iterative alignment? I want to recall an alignment from a previous fixture alignment and then run an iterative alignment on the part on that fixture and report out the exact rotations and translations used to transform from one alignment to the next.
Very cool. Thank you very much for posting that addition. I'm going to work all of these methods out to make sure I understand them fully. In this field it is probably not possible to know too much about how to make these type of calculations.
Very cool. Thank you very much for posting that addition. I'm going to work all of these methods out to make sure I understand them fully. In this field it is probably not possible to know too much about how to make these type of calculations.