Another instance of my programmer and I butting heads. First off, I want to ask... Is an alignment needed to measure the concentricity of 2 circles? If so, can a proper alignment be made with paint on the plane that we are leveling the part to? He says that even with paint (very uneven paint) on the part, the concentricity will be accurate. Again, be gentle.
dph51, you are correct!!! ASME dosen't really recognize concentricity. Concentrecity is abroad and abuse call-out by many. what many folks may be looking its position. with ISO the story may be different...
I think what is usually really needed is
runout. position calc's the location of the
axis of a circle, runout measures whats going on on the
surface of a circle. I hope pcdmis knows the difference...
dph51, you are correct!!! ASME dosen't really recognize concentricity. Concentrecity is abroad and abuse call-out by many. what many folks may be looking its position. with ISO the story may be different...
I think what is usually really needed is
runout. position calc's the location of the
axis of a circle, runout measures whats going on on the
surface of a circle. I hope pcdmis knows the difference...
