hexagon logo
Register Sign in
  • Replies 8 replies
  • Subscribers 222 subscribers
  • Views 173 views
  • Users 0 members are here
Options
Related

Probe changer won't remember slot changes

seppley
I changed the tip in one of the slots in the probe changer, it works fine until i turn off Pc-Dmis. The next time I load Dmis it reverts back to thinking the old tip is in that slot still. So i have to tell it again what is going on, and then it will work again until the next time i shut down.

Not a big problem.. just an annoying one.
Any thoughts?
This never happened to me in Dmis 2011... everytime i upgrade I find new bugs to overcome!
sam
Parents
  • The probe changer information is stored in a file called 'toolc.dat'.

    The most likely reason is that you don't have permissions to update this file. You can verify this by finding this file on your computer and checking the last time it was updated. I believe in Windows 7 it is under c:\programdata\wai\...

    The changes that you make in PC-DMIS would remain until you exit the software.

    +1
    You can also check your rights on this file (you must have "write or all controls)
Reply
  • The probe changer information is stored in a file called 'toolc.dat'.

    The most likely reason is that you don't have permissions to update this file. You can verify this by finding this file on your computer and checking the last time it was updated. I believe in Windows 7 it is under c:\programdata\wai\...

    The changes that you make in PC-DMIS would remain until you exit the software.

    +1
    You can also check your rights on this file (you must have "write or all controls)
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement