If all you need is location, why not just put the pitch (.0357) into your circle probing parameters?
+1 & for good measure probe another circle 0.005" higher than the 1st circle in Z (assuming Z+ WP) then another 0.005" lower than the 1st one.
That is what I will probably end up doing.
I would rather be probing on a smooth surface rather than on jaggy threads. We will be using a thread mill (and for this thread that is new to us) and the TP tolerance is kinda tight at .008".
If all you need is location, why not just put the pitch (.0357) into your circle probing parameters?
+1 & for good measure probe another circle 0.005" higher than the 1st circle in Z (assuming Z+ WP) then another 0.005" lower than the 1st one.
That is what I will probably end up doing.
I would rather be probing on a smooth surface rather than on jaggy threads. We will be using a thread mill (and for this thread that is new to us) and the TP tolerance is kinda tight at .008".
