Your Products have been synced, click here to refresh
Yeah, the center will stay the same, but if the TP has a MMC callout, you'll need an accurate diameter. I've used cylinder probes to measure TP @ MMC of threads in the past with great results.
You mean you got results that said they were ok.
cylinder probes cannot be calibrated by pcdmis.
if you cant calibrate it you cant use it.
Well, that may be the case. We have no problems calibrating our 2mm cylinder probe. We also back up our results with manual methods (gage pins, micrometers, etc.) and the measurements are always the same.
Could you please provide some information that says cylinder probes can't be calibrated?
just search cylinder or shank probes there are tons of threads on here explaining why. I think I even have a couple of threads myself on this subject. I use to check dovetail o ring grooves with a shank probe untill I realized the uncertainty of using them.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |