Good afternoon everyone. We have as one of our CMM's, a "ONE" machine and as of late as we crank up the speed of run of any of the proven PCDMIS programs to near 90-100% the machine stops and displays this error, "TR-FG 117, Y Amplitude Error" Any ideas what's going on with this? Usually this is tech support question but we're hoping a "quicker" response then thru the normal tech channels. Thanx.
We had the similar issue, at a certain area on the table it would give the Y axis amplitude error. Replaced the Y axis card in controller and, in our case, haven't had an issue since.
We had the similar issue, at a certain area on the table it would give the Y axis amplitude error. Replaced the Y axis card in controller and, in our case, haven't had an issue since.