hexagon logo
Register Sign in
  • Replies 17 replies
  • Subscribers 224 subscribers
  • Views 193 views
  • Users 0 members are here
Options
Related

'DOF: M54' Alarm

MatthewHaines
We are having movement issues with our CMM. During a programme the CMM stops and it tells us "DOF: M54 invalid machine not in manual mode".

The machine is in the middle of a programme, it all runs in DCC mode. So we are unsure why it is implying we should be in Manual mode to move from A-B along an axis. Even in the middle of a calibration run the CMM stops and shows this message.

If we press 'continue' it carries on like normal, so it looks like some sort of jolt or glitch. We can't have someone stand next to the CMM pressing 'continue' every two minutes during a programme, so we would like to solve this issue.

What is it, and why is it doing it?

PC-DMIS 2013. Tesa Micro Xcel. PH10T. Browne & Sharpe controller.
Parents
  • If, as I suspect, it is Sharpe, then you need an update. It was fixed after the 2013 Release. It is available in the following -
    2013 Custom #23 and above
    2013 MR1 #638 (from May 9, 2013) and above.

    I followed the steps you posted and we have a B&S Sharpe DCC.

    I shall download the MR1 version and see what happens. We don't rely on PC-DMIS on this CMM yet, so if it doesn't work we don't lose anything.

    I shall post back if it doesn't, thanks for your help so far.
Reply
  • If, as I suspect, it is Sharpe, then you need an update. It was fixed after the 2013 Release. It is available in the following -
    2013 Custom #23 and above
    2013 MR1 #638 (from May 9, 2013) and above.

    I followed the steps you posted and we have a B&S Sharpe DCC.

    I shall download the MR1 version and see what happens. We don't rely on PC-DMIS on this CMM yet, so if it doesn't work we don't lose anything.

    I shall post back if it doesn't, thanks for your help so far.
Children
No Data
© 2025 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement