True position of... length?

I have a round slot, 17 mm from edge of radius to edge of radius and 4mm wide.

My drawing says
17 +/- 0.3
|TP|0.5 MMC |A|B|C| (length)
Boundary

4+/- 0.3
|TP|0.2 MMC |A|B|C| (width)
Boundary

How do I report that?

Parents

russell dunham over 11 years ago

On your report what do you report for BOUNDARY?

In my case, we are assemblers. Our sister plants create our stampings. Boundry was covered during the stamping phase, spent many hours reviewing dimensionals related to this product. (Large product, 90+parts to assemble a rear frame for a GM vehicle). GM supplies their own large stampings (yeah our customer is also our supplier ). I wanna go work for them as all the data I ever get from them is a scan of the part that is best fit, not the gd&t assigned datums. GM hasn't questioned my PPAP sumbissions in the 3 years I have been here.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

russell dunham over 11 years ago

On your report what do you report for BOUNDARY?

In my case, we are assemblers. Our sister plants create our stampings. Boundry was covered during the stamping phase, spent many hours reviewing dimensionals related to this product. (Large product, 90+parts to assemble a rear frame for a GM vehicle). GM supplies their own large stampings (yeah our customer is also our supplier ). I wanna go work for them as all the data I ever get from them is a scan of the part that is best fit, not the gd&t assigned datums. GM hasn't questioned my PPAP sumbissions in the 3 years I have been here.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data