Hi there
I have a single feature control frame that tolerances 31 holes (FCFLOC15) I would like to extract each holes deviation from nominal position via assignments to do this normally I would
use the following assignment "ASSIGN/V1=FCFLOC15.Z.DEV" the only trouble is this only gives the deviation for the 1st hole in FCFLOC15 how if possible can you extract the other
30 'Z' deviations is there some sort of extension to go after the FCFLOC15 ?
Regards Tim.
The features are not looped. the program is set out to measure all features then re-evaluate the datum's then tolerance all the features based on there new alignment, I just require some sort of extension to extract each of the 31 holes out of FCFLOC15 ?
Tim
The features are not looped. the program is set out to measure all features then re-evaluate the datum's then tolerance all the features based on there new alignment, I just require some sort of extension to extract each of the 31 holes out of FCFLOC15 ?
Tim