Hi there
I have a single feature control frame that tolerances 31 holes (FCFLOC15) I would like to extract each holes deviation from nominal position via assignments to do this normally I would
use the following assignment "ASSIGN/V1=FCFLOC15.Z.DEV" the only trouble is this only gives the deviation for the 1st hole in FCFLOC15 how if possible can you extract the other
30 'Z' deviations is there some sort of extension to go after the FCFLOC15 ?
Regards Tim.
I think you can still use Xact if you want to. You just need to create a separate dimension for each hole in Xact instead of dimensioning them all together.
I think you can still use Xact if you want to. You just need to create a separate dimension for each hole in Xact instead of dimensioning them all together.