I have dealt with these a few times, but when programming, how exactly do you measure a pierce point? I have a part now that has a pierce point to a plane, that is at a slight angle off of my datum -b- hole. How would I go about figuring out exactly where this point is and how to report it?
Measure your hole as a cylinder
Measure your face as a plane (assumimg it's meant to be flat)
Insert>Feature>Constructed>Point
In the Help files it says something along the lines of
Constucts a point where feature 1 pierces the surface of feature 2. If the first feature is a line, the diections is important. Order of selection is important.
Measure your hole as a cylinder
Measure your face as a plane (assumimg it's meant to be flat)
Insert>Feature>Constructed>Point
In the Help files it says something along the lines of
Constucts a point where feature 1 pierces the surface of feature 2. If the first feature is a line, the diections is important. Order of selection is important.
