hello everyone I have a gage I need to measure but cant seem to figure out how to do the alignment. I cant use a 3-2-1 alignment because the CAD model doesn't match the part, which is fine but I cant seem to get this figured out. I start off by leveling to the top face, then taking 2 points on the front face just for a rotation, and I then take a point at the flat of the left hex for my Y origin. the only thing I cant figure out is how to get the x origin, there is no surface on the inside of the hex that will work, ideally I want my origin to be dead center of the left hex, but am struggling. again, the perimeter of the CAD model does not match the part.
I will try to post a pic of the model below. Thanks for any help!
ok, thanks I wasn't thinking. I got it figured out, I measured 4 of the sides on the hex as planes, constructed 2 midplanes then just made a midline, set my XY there. I just had to change how I was going about it. Thanks for the help!
ok, thanks I wasn't thinking. I got it figured out, I measured 4 of the sides on the hex as planes, constructed 2 midplanes then just made a midline, set my XY there. I just had to change how I was going about it. Thanks for the help!
