Report Pop Up

Would the following even work?

I would like the operator to review the report, insert a comment at the end and the print it to a pdf. Our process is to run a part, read a report after it prints and the program is complete, and then gage any diameters that appear to be out. We need a comment at the end of the report that states the part was gaged. Any thoughts??

I've been playing with a few things but cannot get what I want exactly.

Thanks in advance.

No pressure, but this is HOT.

Parents

Wes Cisco over 10 years ago

Howdy John,

The best option may be to add a box of text to the end of the pdf with an editor. I use one called PDF Xchange Viewer I downloaded for free. I like it better than Adobe. Just make certain there is a blank area large enough on the last page of the report, maybe use report comments to make that happen. This has the advantage that it can be done at any pc and while the next part is running.

HTH
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Wes Cisco over 10 years ago

Howdy John,

The best option may be to add a box of text to the end of the pdf with an editor. I use one called PDF Xchange Viewer I downloaded for free. I like it better than Adobe. Just make certain there is a blank area large enough on the last page of the report, maybe use report comments to make that happen. This has the advantage that it can be done at any pc and while the next part is running.

HTH
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data