Importing CMM results into a CAD software (SOLIDWORKS) for comparison

Hello All,

An engineer has asked me if I am able to import the CMM result I get into SOLIDWORKS so they can compare it to the CAD model. I have never tried and I don't know where to start. Is it possible? If so, how can I do it? I will try to research the topic and I hope I can get someone's help in this forum to help me along. Any help would be greatly appreciated! Thanks in advance...

Parents

Josh Carpenter over 10 years ago

I need to move my post to "what has DMIS done for me" in the OFF TOPIC. As in "feel stupid" yet again... I will look into that a bit closer tomorrow. Thanks Josh.

Don't worry about it, I get schooled on PC-DMIS all the time by folks (some here) who know waaayyyy more than me.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Josh Carpenter over 10 years ago

I need to move my post to "what has DMIS done for me" in the OFF TOPIC. As in "feel stupid" yet again... I will look into that a bit closer tomorrow. Thanks Josh.

Don't worry about it, I get schooled on PC-DMIS all the time by folks (some here) who know waaayyyy more than me.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data