I am measuring this part right now this is a cylinder about 3 inches tall. The od is dat-b. The top plane is dat-a and dat-c is a slot in the center of the part. The part has 4 counter bore holes along the side of it every 90 degrees. Here is a picture of what the result looks like, and i know its wrong.
Do i need the od dat to be a cylinder or a circle?
Does it matter if its a constructed cyl or an auto cyl?
My dat c is a constructed width, should it be the line instead?
I was assuming that A and B were already aligned. Is this your argument?
Its not an argument, it a fact. If you do not have a -C- Slot, the you could do the BF rotate ONLY, but since you have a specific -C- that locks 2 DOF, you are not allowed to perform a BF any longer
I was assuming that A and B were already aligned. Is this your argument?
Its not an argument, it a fact. If you do not have a -C- Slot, the you could do the BF rotate ONLY, but since you have a specific -C- that locks 2 DOF, you are not allowed to perform a BF any longer
