I am measuring this part right now this is a cylinder about 3 inches tall. The od is dat-b. The top plane is dat-a and dat-c is a slot in the center of the part. The part has 4 counter bore holes along the side of it every 90 degrees. Here is a picture of what the result looks like, and i know its wrong.
Do i need the od dat to be a cylinder or a circle?
Does it matter if its a constructed cyl or an auto cyl?
My dat c is a constructed width, should it be the line instead?
Right, he has a Slot, so he can eother use one edge or a Mid line from the slot for rotation. What do you mean by "ise BF rotate as -C-??"
QUOTE=VinniUSMC;389049]He said "My dat c is a constructed width, should it be the line instead?"
What was suggested was to use BF Rotate
as the Dat C rotation. What was not suggested was to rotate 2 different times.
Right, he has a Slot, so he can eother use one edge or a Mid line from the slot for rotation. What do you mean by "ise BF rotate as -C-??"
QUOTE=VinniUSMC;389049]He said "My dat c is a constructed width, should it be the line instead?"
What was suggested was to use BF Rotate
as the Dat C rotation. What was not suggested was to rotate 2 different times.
