I am beginning to attempt to program off a cad model. I have a sample part, every time I press cad=part my alignment moves off my cad model. I am actually trying to program off of cad on a part I have a sample for before I make a program off a part that I have no sample for.
I had programmed using a cad model before but needed the help of a more senior member of the team help me set it up. I have been programming since then on my own with no tutor and only cad level 1 training. Is there some more information some where that can teach me what I need to do to use a cad model because so far I'm not doing so well. You all help me with a lot of things but some things just go over my head.
level II training.
can you or do you have the ability to TRANSLATE your cad model?
I had programmed using a cad model before but needed the help of a more senior member of the team help me set it up. I have been programming since then on my own with no tutor and only cad level 1 training. Is there some more information some where that can teach me what I need to do to use a cad model because so far I'm not doing so well. You all help me with a lot of things but some things just go over my head.
level II training.
can you or do you have the ability to TRANSLATE your cad model?
